Process 1: Apply thread sealant or wrapping sealing tape to the two joints, and then screw them into the cold and hot water supply pipes. Adjust the two joints so that the center distance is 150mm and the joint is level; The central decorative cover is screwed into the joint, which is close to the wall after decoration; After installing the sealing gasket into the nut, screw it onto the joint and tighten it. Install the gasket into both ends of the shower hose, and then connect one end of the shower hose to the outlet of the tap, and the other end to the shower.

Process 2: First pull the fixing pin off the bracket, and then take out the plastic sleeve. Take out the screws and expansion plugs in the bracket cavity. Select the position of a device bracket at the height accessible to the shower hose. Mark the position of the bottom plate of the device bracket on the wall, and drill two holes according to the mark. Insert the expansion plug into the hole, then screw the tapping screw into the expansion plug through the plastic sleeve as shown in the figure, and tighten it with a screwdriver. Insert the groove of the bracket inner wall into the boss of the plastic sleeve, and then press the push pin into the fixing hole of the bracket.

Article Source:www.jiangsu-spray.com Kaiping Shower Block Wholesale